SikaCeram®-282 Fibre Reinforced

BS EN 12004 Class C2 TE S2

Cement, aggregates and specialist additives.

12 months from date of manufacture when stored as directed.

This product must be stored in unopened bags clear of the ground in cool dry conditions and protected from excessive draught. 

The use of this product after the end of declared storage period may increase the risk of an allergic reaction.

4 hours dependant on temperature and site conditions.

24 hours dependant on temperature and site conditions.

Approximately 4 Kg/m² when applied as directed.

SikaCeram®-282 Fibre Reinforced should be added to clean water. Mix approximately 20 kg powder with approximately 5.5 litres of clean water and mix to a slump free mortar. Please note that the consistency of the paste can be adjusted with slight additions of water during the mixing stage only. Never add further water once the adhesive has started to go off. This will destroy the bond strength. Always add powder to water.

All surfaces should be clean, dry and free of dust and loose material before commencing. Refer to above for specific surface preparation.

Use a notched trowel to give a ribbed mortar bed on the substrate, to which the tiles should be firmly bedded with a twist and slide action to ensure full contact.

• Use a 3 mm x 3 mm notch at 6 mm centres for mosaics and thin flat backed wall tiling.
• Use a 5 mm x 5 mm notch at 10 mm centres for general wall tiling.
• Use 10 mm x 10 mm notch at 16 mm centres for general floor tiling.

SikaCeram®-282 Fibre Reinforced will remain workable for up to 4 hours depending on absorbency of substrate and temperature. Lightly touch the adhesive periodically and if a skin has formed, remove the adhesive and apply a new layer. It is good practice to periodically remove a tile and check that the adhesive covers a minimum of 75 % of the tile.

All surplus adhesive must be removed whilst the adhesive is still wet using a dampened cloth or sponge, particularly along the grout lines.

Grouting may proceed as soon as the tile bed is sufficiently firm, which will be around 24 hrs at room temperature. This period, however, will be extended in cold conditions.

When the adhesive is fully set, wall and floor joints can be grouted using SikaCeram^® CleanGrout.

Subfloor Heating

Fixing over a heated sub-floor requires adhesive to cure for at least 2 to 3 weeks before switching on the heating and gradually raising the set temperature by 2 °C per day until the floor is at its required operating temperature.

Clean tools in water after use. Wash hands immediately after using this product.