Product Data Sheet Show all documents
EVERBUILD STICK2® Rapid Epoxy Tube

EVERBUILD STICK2® Rapid Epoxy Tube

INDUSTRIAL STRENGTH 2-PART ADHESIVE SYSTEM

EVERBUILD STICK2® Rapid Epoxy Tubeis an industrial strength, two-part, clear adhesive system which, when mixed, sets hard in just 4 minutes. Due to its exceptional strength this product may be drilled, sanded, machined and painted once fully cured.

  • Industrial strength
  • Sets hard in just 4 minutes
  • Non-drip formula
  • May be drilled, sanded, machined and painted once fully cured
Product Data Sheet Show all documents

Usage

Ideal for bonding metals, crockery, glass, wood, china, dry concrete, rubber, fabrics, crystal, jewellery/precious stones and various hard plastics  

Advantages

  • Industrial strength
  • Sets hard in just 4 minutes
  • Non-drip formula
  • May be drilled, sanded, machined and painted once fully cured

Packaging

2 x 12ml tubes

Colour

Clear

Product Details

Product Information

Shelf Life

3 years from date of manufacture.

Storage Conditions

Store vertically in a cool, dry ventilated place between +5°C and +25°C. Protect from frost. Storage outside these parameters will dramatically reduce shelf life.

Application

Application steps

APPLICATION INSTRUCTIONS

Ensure surfaces are clean, dry and are free from flaking material, dust, rust and grease. Roughen surfaces with sandpaper to improve adhesion.

Squeeze out equal quantities of the resin and hardener from their separate tubes into the mixing tray provided and mix for 30 secs to 1 minute. Mixed adhesive is usable for only 4 minutes. Only mix small quantities in one go.

Apply adhesive immediately to both surfaces. Assemble and hold/clamp until adhesive starts to cure. Note: adhesive will cure faster at higher temperatures and, conversely, slower at low temperatures. At 20°C the adhesive sets hard in 4 minutes and is fully cured in 12 hours. Carefully remove any residual adhesive with a sharp knife before adhesive sets.

CLEANING OF TOOLS

Clean uncured adhesive from tools etc with acetone or nail varnish remover, protecting surrounding surfaces. Cured adhesive must be mechanically removed.

 

Documents