Product Data Sheet Show all documents
Feb® Brickclean

Feb® Brickclean

Acid based cleaning solution for brick, concrete & stone surfaces.

Feb® Brickclean is a fast acting acid based cleaner solution which dissolves mortar and cement stains, ingrained dirt and most paints on mineral surfaces such as brick, stone, concrete, paving slabs and earthenware.

  • Multi purpose stain remover.
Coverage Up to 10 m2  per litre, dependent upon porosity or contamination of substrate. Active Acid Content <10 % w/w
Product Data Sheet Show all documents

Usage

  • Cleaning of brickwork and floors where efficient cleaning is required.
  • Suitable for etching of concrete surfaces as preparation for epoxy resin screeds and toppings etc.
 

Advantages

  • Multi purpose stain remover.
Coverage Up to 10 m2  per litre, dependent upon porosity or contamination of substrate. Active Acid Content <10 % w/w

Packaging

5 Ltr Jerry Can.

Colour

Clear transparent liquid with similar viscosity to water.

Product Details

Product Information

Chemical Base

Hydrochloric acid.

Shelf Life

24 months from date of manufacture when stored as directed in unopened containers.

Storage Conditions

Store in cool dry conditions away from direct sunlight between +5 °C and +30 °C. Avoid contact/storage near strong alkalis/bleach. Store away from children.

Application

Application steps

APPLICATION

Mixing

To prevent discolouration or damage to substrates it is recommended that the optimum strength of solution be established by applying test areas starting at a 2:1 water/cleaner dilution.

Application

Areas of severe contamination may require more than one treatment using neat Feb® Brickclean. The product should be applied by brush using a scrubbing action. Rinse off with plenty of water before drying out occurs. Where etching of concrete is required prior to application of epoxies, use undiluted, scrub well in with a stiff bristle brush, allow about 20 minutes to act (less in hot weather) and then liberally hose down to completely wash away all the solution. Allow to dry out prior to application of the epoxy.

Documents