Product Data Sheet Show all documents
EVERBUILD CEMSTRIP®

EVERBUILD CEMSTRIP®

Environmentally-friendly concentrated cement remover

EVERBUILD CEMSTRIP® is a new type of cement, concrete and mortar stain remover that provides a more environmentally-friendly alternative to conventional hydrochloric acid based cement removers. EVERBUILD CEMSTRIP® will also remove salts and efflorescence from the surface of mineral substrates and is a very effective general cleaner for removing ingrained dirt, grease and stains from paths and patios. EVERBUILD CEMSTRIP® is a highly concentrated formula that can be diluted up to 10 times with water to suit a variety of applications. Unlike hydrochloric acid based products EVERBUILD CEMSTRIP® can be safely used on most metal surfaces such as tools, cement mixers and other building equipment.  

  • Available in bottles or as a ready-to-use spray.
  • Water clean-up.
  • Economical, makes up to 10 times the volume of the bottle when diluted.
Product Data Sheet Show all documents

Usage

  • Removes cement, mortar and concrete on most mineral surfaces such as paths, patios and walls.
  • Cleaning tools, cement mixers and other building equipment.

Advantages

  • Available in bottles or as a ready-to-use spray.
  • Water clean-up.
  • Economical, makes up to 10 times the volume of the bottle when diluted.

Packaging

1L and 5L plastic containers, 1L sprayable container

Colour

Thin green/yellow liquid

Product Details

Product Information

Shelf Life

24 months form date of manufacture.

Storage Conditions

KEEP AWAY FROM CHILDREN. Store away from alkaline products and bleach at 5°C to 25°C

Density

1.09g/cm³ at 20°C

pH-Value

1.4 - 1.7

Application

Consumption

Yield

Approx. 10m2 per litre depending on porosity of substrate.
Application steps

MIXING

9 parts water to 1 part EVERBUILD CEMSTRIP® –  Cleaning general stains and ingrained dirt from paths, patios and horizontal surfaces.

2 parts water to 1 part EVERBUILD CEMSTRIP® – Cleaning light mortar stains from paths, patios, walls or vertical surfaces.

1 part water to 1 part EVERBUILD CEMSTRIP® – Cleaning heavy mortar stains from walls or vertical surfaces.

Neat – Cleaning tools, cement mixers and other building equipment.

SUBSTRATE PREPARATION

When cleaning paths, patios, cement stains etc. from surfaces always thoroughly wet surfaces prior to application. Do not apply to a dry surface. Always test a small inconspicuous area prior to full application. When cleaning tools and equipment pre-wetting is not necessary.

APPLICATION

General Cleaning:

Moisten surfaces with water and apply EVERBUILD CEMSTRIP® with brush or low pressure spray (avoiding mist formation) from the top of the area downwards. Leave for 5-10 mins then scrub/wash off with a hose, brush or power washer until the surface is clean. Never allow the product to dry on surfaces. Where a second application is necessary, repeat the procedure above.

Cleaning tools/equipment:

EVERBUILD CEMSTRIP® will remove fresh cured cement and wet or semi-cured cement from tools. Spray onto item in question. Leave for 15 mins to act (light stains) or up to 3 hours for heavy contamination. Wash off the product with clean water. Use of a scourer will assist removal of stubborn stains. Use a hot power wash to assist removal of staining from mixing equipment. After removal, always spray tools with Everbuild® XT44 Maintenance Spray (or any other proprietary maintenance spray) to prevent further corrosion/rust.

Documents