Product Data Sheet Show all documents
EVERBUILD® 701 Non Slip Tile Adhesive

EVERBUILD® 701 Non Slip Tile Adhesive

SHOWERPROOF Acrylic based tile adhesive giving extra grab and slip resistance

EVERBUILD® 701 Non Slip Tile Adhesive is a showeproof acrylic based formula for extra slip resistance and grab. Designed for general use in bathroom and kitchen areas. May be used in domestic showers when used in conjunction with Everbuild Powdered Wall Tile Grout.

  • Ready mixed formula - no mixing, no mess. Apply straight from the tub
  • Acrylic based - Excellent non slip characteristics - no movement on a 300 x 200 standard large format wall tile
  • Extended open time
  • Extremely high bond strength - nearly 3 x the British Standard minimum requirement
Product Data Sheet Show all documents

Usage

  • Designed for general use in bathroom, kitchen & shower areas
  • For use with ceramic and porcelain wall tiles & Mosaics
  • Thin bed tile adhesive for extra slip resistance and grab
  • Easy to trowel with good wet edge
 

Advantages

  • Ready mixed formula - no mixing, no mess. Apply straight from the tub
  • Acrylic based - Excellent non slip characteristics - no movement on a 300 x 200 standard large format wall tile
  • Extended open time
  • Extremely high bond strength - nearly 3 x the British Standard minimum requirement

Packaging

3.75 kg, 7.5 kg and 14 kg tubs

Colour

Off white

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

EN12004 type D1T.
Product Information

Chemical Base

Acrylic

Shelf Life

12 months in original unopened container.

Storage Conditions

Store in cool (+5 to +25 °C) dry conditions. Protect from frost.

Density

1.7 g/cm3
Technical Information

Shear adhesion strength

22.9 kN (Minimum:8.9 kN BS5980)

Service Temperature

-30 °C to +100 °C

Application

Application Information

Layer Thickness

3-6 mm

Open Time

20 - 30 mins @20 °C

Curing Time

24-72 hours (depending on substrate)
Consumption

Consumption

Approximately 0.6 m²/kg (6 mm notched trowel) to 0.5 m²/kg (solid bed).
Application steps

APPLICATION

Apply EVERBUILD® 701 Non Slip Tile Adhesive to wall at a depth of 3-6 mm (no less than 3 mm, no greater than 6 mm) combing out an area no greater than 1 m² at a time.  In dry situations, use a suitable notched trowel across the surface of the adhesive before placing the tiles into position and securing with a slight twist action to remove air voids.

In areas subject to wet conditions, do not use a notched trowel. Bed the tiles directly into the surface of the adhesive and again, secure with a slight twist action. In both situations, it is good practice to periodically remove a tile and check that at least 75 % of the tile is covered in adhesive. If this is not the case, apply fresh adhesive and reposition.

All surplus adhesive must be removed whilst adhesive is still wet using a dampened cloth or sponge, particularly along grout lines.

CLEANING OF TOOLS

Clean tools in water after use. Wash hands with warm water and soap after use.

Documents