Product Data Sheet Safety Data Sheet Show all documents
EVERBUILD® Lead Mate® Sealant

EVERBUILD® Lead Mate® Sealant

A LOW MODULUS NEUTRAL CURE SEALANT FOR LEAD

EVERBUILD® Lead Mate® Sealant is a low modulus, neutral cure sealant specifically designed to give exceptional adhesion to soft metals such as lead, brass etc. The product is specially formulated as an alternative to mortaring Lead Flashing and Sheet into Brick, Stone and Concrete.

  • Excellent adhesion to metals - will not stain (cement) or corrode soft metals unlike most conventional sealants
  • Low dirt pick up
  • Excellent flexibility +/- 25%.
  • Excellent low and high (+150°C) temperature resistance.
  • Low (<5%) shrinkage during vulcanisation.
  • High resistance to plasticizer migration - may be used over water based and solvent based paints.
  • Excellent external weathering properties.
  • Certified under the harmonized European standard EN15651 for façade interior, exterior and cold climate applications in compliance with the Construction Product Regulation
Shrinkage <5% Tensile Modulus at 100% Elongation ca. 0.3MPa 
Seek a Stockist Contact Us
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • As an alternative to mortaring in Lead flashing and sheet into brick, stone and concrete.
  • Suitable as an expansion joint sealant.
  • Weather sealing and joint sealing to pre-formed panels.
  • Sealing soft metals such as lead, copper and zinc.
  • Parapet and roof weather sealing applications.
 

Advantages

  • Excellent adhesion to metals - will not stain (cement) or corrode soft metals unlike most conventional sealants
  • Low dirt pick up
  • Excellent flexibility +/- 25%.
  • Excellent low and high (+150°C) temperature resistance.
  • Low (<5%) shrinkage during vulcanisation.
  • High resistance to plasticizer migration - may be used over water based and solvent based paints.
  • Excellent external weathering properties.
  • Certified under the harmonized European standard EN15651 for façade interior, exterior and cold climate applications in compliance with the Construction Product Regulation
Shrinkage <5% Tensile Modulus at 100% Elongation ca. 0.3MPa 

Packaging

295ml cartridge

Colour

Lead grey

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

Conforms to ISO11600 F25 LM and EN15651-1 Class F25LM CC
Product Information

Chemical Base

Neutral cure silicone

Shelf Life

12 months from date of manufacture

Storage Conditions

Store in original unopened containers between 15 and 30°C

Density

1.3-1.4g/cm3
Technical Information

Shore A Hardness

20-30

Tensile Strength

0.6MPa (ISO8339 at break)

Elastic Recovery

>70% (ISO7389)

Movement Capability

+ or -25%

Service Temperature

-50°C to + 150°C

Joint Design

6-40mm

Maximum depth, 50% of joint width

Application

Application Information

Ambient Air Temperature

+5°C to + 40°C

Skin Time

30 - 45 mins
Consumption

Consumption

10.5 linear meters as a 6mm diameter bead
Application steps

SUBSTRATE PREPARATION

The surfaces to be must be clean, dry and free from dust, grease and other contaminants.

Priming is generally not required, although we always advise testing small areas prior to use.

CLEANING OF TOOLS

Uncured sealant white spirit, cured sealant EVERFLEX SILICONE EATER.

Documents