Product Data Sheet Show all documents
EVERBUILD® Silicone Eater

EVERBUILD® Silicone Eater

A SILICONE SEALANT REMOVER

EVERBUILD® Silicone Eater is specifically designed to remove all silicone based sealants and surface water repellents - cured and uncured. The product acts by denaturing silicone polymers making them easily water or solvent rinsable.

  • Readily denatures silicone.
  • Ready for use gel - may be used vertically as well as horizontally.
  • Water clean-up.
Solubility Insoluble in water pH 3 in 100 g/L water Boiling Point205°CVapour pressure0.15 Kpa at 20 °CAuto IGN>200 °C in waterExplosion LimitsN/D
Seek a Stockist Contact Us
Product Data Sheet Show all documents

Usage

  • May be used on aluminum* and its alloys, copper and its alloys, iron, steels, glass, ceramics, epoxy composites, most plastics.
  • Has little effect on rubber and other elastomers.
  • Has little effect on most painted surfaces.
 

Advantages

  • Readily denatures silicone.
  • Ready for use gel - may be used vertically as well as horizontally.
  • Water clean-up.
Solubility Insoluble in water pH 3 in 100 g/L water Boiling Point205°CVapour pressure0.15 Kpa at 20 °CAuto IGN>200 °C in waterExplosion LimitsN/D

Packaging

100 ml cartridge

Colour

Paste

Product Details

Product Information

Shelf Life

24 months from date of manufacture

Storage Conditions

Store in cool dry conditions between +5 °C and +25 °C. AVOID ALL CONTACT WITH MOISTURE

Density

~0.87 g/cm³

Flash Point

~70 °C

Viscosity

1400+/- 600 poise @ 25°C.

Application

Application steps

SUBSTRATE PREPARATION

All surfaces must be clean, dry and dust free. Cut away as much as possible of the silicone sealant using a sharp knife. Protect surrounding areas with impervious masking tape.

Documents