Product Data Sheet Show all documents
EVERBUILD® Lumberjack® 45 Min PU Wood Adhesive

EVERBUILD® Lumberjack® 45 Min PU Wood Adhesive

A professional quality one part moisture curing wood adhesive with rapid setting properties.

This product is a 45-minute set, free-flowing liquid in a bottle.
As well as bonding all common wood types (hard, soft, exotic, painted) EVERBUILD® Lumberjack® 45 Min PU Wood Adhesive will also bond Formica, polystyrene, PU foam, metal and glass wool and various plastics (including PVC) to porous surfaces. This product also adheres to stone, concrete, brick and masonry.

  • Fast setting – 45 min (typical PVA based wood glue = 8-12 hours).
  • Exceptional bond strength to wood and most common building surfaces.
  • Internal and external use - excellent weathering and aging properties.
  • Fully water proof to EN204 D4.
  • Products foam slightly on application to fill small gaps and increase overall bond strength.
  • Excellent chemical resistance.
  Viscosity 200 x103 mPa.s @ 25 ºC Coverage 225 - 355 ml/m² Initial Set Time 45 mins CleanerEverbuild Dual Purpose Foam Cleaner or acetone BEFORE curing. After cure, use mechanical abrasion  
Product Data Sheet Show all documents

Usage

  •  General wood jointing and construction.
  •  Window and door frame manufacture.
  •  Door manufacture.
  •  Furniture manufacture.
  •  Construction of staircases and ladders.
  •  As a high quality insulation adhesive for foam/glasswool/fibre boarding.

Advantages

  • Fast setting – 45 min (typical PVA based wood glue = 8-12 hours).
  • Exceptional bond strength to wood and most common building surfaces.
  • Internal and external use - excellent weathering and aging properties.
  • Fully water proof to EN204 D4.
  • Products foam slightly on application to fill small gaps and increase overall bond strength.
  • Excellent chemical resistance.
  Viscosity 200 x103 mPa.s @ 25 ºC Coverage 225 - 355 ml/m² Initial Set Time 45 mins CleanerEverbuild Dual Purpose Foam Cleaner or acetone BEFORE curing. After cure, use mechanical abrasion  

Packaging

750 g bottle

Colour

Brown

Product Details

Product Information

Chemical Base

100 % prepolymers and catalyst (solvent free)

Shelf Life

12 months

Storage Conditions

Store in original unopened containers between 5 and 25 °C. Reseal immediately once used or disposal will be necessary

Solid content by mass

100 % (solvent free)

Application

Application steps

APPLICATION INSTRUCTIONS

Remove cap, cut spout and apply. Replace cap after use.
Wearing of gloves is recommended. Apply adhesive evenly to one surface. If necessary, cover large areas with a fine toothed spreader. Assemble parts IMMEDIATELY and clamp for duration of cure (45 minutes at 20 °C; longer at lower temperatures). After this time, the joint may be easily handled. Full and final bond strength will be achieved after 24 hours.
NOTE: These products foam slightly on application to fill small gaps. Any excess foam/adhesive must be removed with acetone before the product sets or with a sharp chisel once set.

 

SUBSTRATE PREPARATION

The surfaces to be glued should be clean and free from dust, grease and other contaminants. At least one of the materials must be porous. Roughen non-porous surfaces to give a key for the adhesive. To assist cure and achieve maximum bond strength, slightly moisten one surface with a damp cloth. Do not over wet.

Documents