Product Data Sheet Show all documents
EVERBUILD® 405 Path & Patio Seal

EVERBUILD® 405 Path & Patio Seal

A long lasting, solvent free, acrylic coating for paths and patios

EVERBUILD® 405 Path & Patio Seal is a solvent free acrylic coating used to seal and protect patios, paths, natural stone, concrete and block paving from the effects of sunlight, water, oil, petrol and organic growth. The milky solution dries to a hard wearing water repellent film which gives a low sheen, slip resistant finish which will reduce dirt pickup and facilitate easier cleaning. The product is safer to use than conventional solvent based products, i.e. it is non-flammable and will not harm plants and animals when used as directed.

  • Solvent free formulation – non-flammable, low odour.
  • Improves appearance of paths/stone.
  • Also acts as a dustproofer and facilitates easier cleaning.
  • Dramatically improves water and mark resistance - High degree of water repellency in dried film.
  • Contains a powerful fungicide – prevents unsightly growth in the film.
M.F.F.T ca 0°C Drying Time 4 Hours
Product Data Sheet Show all documents

Usage

Where it will protect from the effects of sunlight, water, oil, petrol and organic growth on:
  • Paths
  • Patios
  • Natural stone
  • Concrete
  • Block paving
 

Advantages

  • Solvent free formulation – non-flammable, low odour.
  • Improves appearance of paths/stone.
  • Also acts as a dustproofer and facilitates easier cleaning.
  • Dramatically improves water and mark resistance - High degree of water repellency in dried film.
  • Contains a powerful fungicide – prevents unsightly growth in the film.
M.F.F.T ca 0°C Drying Time 4 Hours

Packaging

5ltr and 25ltr

Colour

Milky solution (water based), dries clear.

Product Details

Product Information

Shelf Life

12 months when stored according to manufacturers instructions.

Storage Conditions

Store between 5°C and 25°C temperatures in original containers. PROTECT FROM FROST.

Density

ca. 1.01 g/cm³ @ 20°C

Solid content by weight

ca. 14% w/w

Application

Consumption

Consumption

1 Litre will cover approximately 8m² per coat depending on nature of surface
Application steps

APPLICATION

Stir well before use. May be applied to damp (but not wet) surfaces. Apply using a long pile roller and tray or low-pressure spray. Ensure even and thorough coverage, especially on textured finishes where ponding of the material MUST be avoided. Apply in two coats, allowing no more than 2 hours between coats. An extra coat may be applied if a semi gloss finish is required. Drying time will be 4 hours from last coat at 20°C. This will be extended at lower temperatures. Do not apply below 5°C.

CLEANING OF TOOLS

Clean tools with warm soapy water before the product dries on them

CLEANING

Areas treated with this product can be cleaned with warm water and detergent or Everbuild Patio Wizard. Do not use acid based cleaners, as these will remove/discolour the product. Avoid using power washers.

Documents