Product Data Sheet Show all documents
EVERBUILD® 404 Fungicidal Wash

EVERBUILD® 404 Fungicidal Wash

powerful, fast acting fungicidal wash

EVERBUILD® 404 Fungicidal Wash is a powerful, fast-acting solution which is effective on most surfaces. It quickly removes fungus and lichen from floors, walls, drives and roofs.  It also leaves a residual surface to help prevent further infestation.

  • Internal and external use.
  • Fast acting.
  • Leaves a residual surface to prevent future infestation.
  • Powerful formula.
Freezing Point 0°C approx Active Ingredients Alkyl (C12-16) Dimethylbenzyl ammonium Chloride (0.99%w/w) 2-Phenylphenol. (0.25% w/w) Drying Time 1-12 hours from washdown depending on surface
Product Data Sheet Show all documents

Usage

  • Kills mould and fungal growth caused by damp on internal and external floors and walls.
  • Kills mould and fungal growth on roofs prior to coating with bituminous coatings.
  • Removes algae, lichen, green slime and fungal growth from patios/drives.
 

Advantages

  • Internal and external use.
  • Fast acting.
  • Leaves a residual surface to prevent future infestation.
  • Powerful formula.
Freezing Point 0°C approx Active Ingredients Alkyl (C12-16) Dimethylbenzyl ammonium Chloride (0.99%w/w) 2-Phenylphenol. (0.25% w/w) Drying Time 1-12 hours from washdown depending on surface

Packaging

1ltr and 5ltr plastic containers

Colour

Clear solution

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

Registered with HSE under “Control of Pesticides Regulations; 1986” (HSE 10400).
Product Information

Shelf Life

24  months from date of manufacture when stored according to manufacturers instructions.

Storage Conditions

Store at moderate temperatures in original containers. PROTECT FROM FROST.

Density

1.0 g/cm³ at 20°C

Application

Consumption

Yield

1Ltr will cover approximately 5-10m² of surface depending on nature of surface
Application steps

APPLICATION

Always read label before use and wear suitable protective equipment. Supplied ready to use. Do not dilute. Remove all surface debris and growth from the area to be treated.  Apply by brush or spray at a rate of 1 litre per 5 - 10m2 depending on porosity of surface. Leave solution for 20 minutes. Finally, wash down the area with water. Repeat process for badly infested areas. Take care not to allow residues to run directly into fresh watercourses.

Documents