Product Data Sheet Show all documents
EVERBUILD® Lumberjack® Wood Preserver

EVERBUILD® Lumberjack® Wood Preserver

Penetrates and preserves for long-lasting protection

EVERBUILD® Lumberjack® Wood Preserver is a low odour solution based on Micro-fine active technology. The fungicides and algaecides present in this formulation are finely dispersed so that wood penetration and hence effectiveness is much greater than uncertified wood protection products. In addition the use of ultra-lightfast pigments on the coloured variants gives an even fade-resistant finish which will last for years.  EVERBUILD® Lumberjack® Wood Preserver is fast-drying and non-flammable; application to damp timbers is possible without loss of performance. It is specifically designed to deeply penetrate all wood and joinery to give long-lasting protection from damage caused by wet rot, dry rot, decay and fungi.

  • Micro-Fine Actives penetrate deep into the wood.
  • Non-flammable.
  • Quick drying.
  • Internal and external use.
  • Can be applied to damp timbers.
  • Low odour.
Product Data Sheet Show all documents

Usage

EVERBUILD® Lumberjack® Wood Preserver - Clear: For use on interior or exterior rough-sawn or planed timber such as floorboards, joists, roof timbers, window frames and doors. This product is an ideal pre-treatment which may be overpainted, varnished, or stained when dry (allow up to 48 hours drying time at 20 °C). For interior applications it may also be left as the final finish for a natural wood effect; however, when used externally, overpainting/staining is required. Everbuild Shed & Fence Mate is ideal for this.
NOTE: product is milky out of the can but dries clear.                                                                                                                              
EVERBUILD® Lumberjack® Wood Preserver - Fir Green, Dark Oak, Golden Chestnut, Red Cedar, Slate Grey and Silver Birch: Ideal for general use on rough-sawn or planed timber such as window frames, fences, sheds, cladding, horticultural timber, roof timber, joists etc. Fir Green is particularly useful for easy identification of treated timbers and horticultural work. When used externally it is required that they are stained or varnished.

Advantages

  • Micro-Fine Actives penetrate deep into the wood.
  • Non-flammable.
  • Quick drying.
  • Internal and external use.
  • Can be applied to damp timbers.
  • Low odour.

Packaging

Clear - 1, 5, 25 L tins

Red Cedar, Golden Chestnut, Fir Green, Dark Oak, Silver Birch, Slate Grey - all available in 5 L tins

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

COPR Approval HSE No. 10425
Product Information

Shelf Life

Use within 2 years of manufacture.

Storage Conditions

Store at moderate (+5 °C to +30 °C) temperatures in original containers away from children.

Application

Consumption

Consumption

Use only as supplied (do not dilute). 1 litre will treat 3 – 4 square metres.
Application steps

APPLICATION

Shake well before use. Apply by brush, spray or dipping. Apply a minimum of two coats if brushing or spraying. The second coat should be applied after one hour at 20 °C. Pay particular attention to thoroughly soaking the end grain. Where possible, for maximum protection dip the end grains of the timber for a minimum of 3 minutes.

CLEANING OF TOOLS

Clean all equipment with water before the product dries.

Documents