Product Data Sheet Show all documents
EVERBUILD® Triple Action Wood Treatment

EVERBUILD® Triple Action Wood Treatment

Kills and protects against wood rot, decay, fungi and wood-boring insects.

EVERBUILD® Triple Action Wood Treatment takes care of all your wood treatment and preservation needs in one can. It is a solvent-free, low-odour solution based on Micro-fine active technology with added fungicides, algaecides and Permethrin to actively kill and protect against wood rot, decay, fungi and wood-boring insects. The fungicides and algaecides present in these formulations are finely dispersed so that wood penetration, and hence effectiveness, is much greater than standard wood preservation products. EVERBUILD® Triple Action Wood Treatment is fast drying and non flammable, and application to wet timber is possible without loss of performance. It is specifically designed to deeply penetrate all wood and joinery to give long lasting protection from damage caused by wet rot, dry rot, decay, fungi and wood-boring insects/larvae.  

  • Non flammable.
  • Internal and external use.
  • Can be applied to damp timbers.
  • Penetrates deeply into the wood.
  • Long lasting protection.
  • Fast drying.
Product Data Sheet Show all documents

Usage

For interior and exterior use on wood such as:
  • Sheds and garages.
  • Fencing and farm buildings.
  • Roof beams and joists.
  • Garden furniture.
  • Floorboards.
  • Window frames and doors.

Advantages

  • Non flammable.
  • Internal and external use.
  • Can be applied to damp timbers.
  • Penetrates deeply into the wood.
  • Long lasting protection.
  • Fast drying.

Packaging

1 L, 2.5 L, 5 L and 25 L tins

Product Details

Product Information

Shelf Life

Use within 2 years of manufacture.

Storage Conditions

Store between +5 °C and +25 °C in original containers away from children.

Application

Consumption

Consumption

Use as supplied (do not dilute). 1 litre will treat 3-4 square metres.

 
Application steps

APPLICATION INSTRUCTIONS

Precautionary Notes

ALWAYS READ STATUTORY CONDITIONS RELATING TO USE BEFORE STARTING ANY WORK. Ensure good ventilation before applying and after application until the treatment has dried (HSE statutory 1 hour re-entry time or until surfaces are dry) NOTE: drying times will be extended in cold weather and if ventilation is restricted. Avoid contact with skin and eyes, remove any splashes immediately. Clean up spills immediately (to avoid staining) with warm soapy water.

In roof areas, felt under tiles must be protected from contact with the fluid. Roof insulation must be removed and only replaced when treated timbers are thoroughly dry. Water storage tanks must be covered.

When treating flooring and joists, boards should be left up for as long as possible to assist ventilation/drying.

Switch off electrical circuits in the area being treated before, and until 48 hours after, treatment. PVC covered electrical wiring will not normally be affected, but it is recommended that any excess is wiped from cables wherever possible.

APPLICATION

Shake well before use. Apply by brush, spray or dipping. Apply a minimum of two coats if brushing or spraying. The second coat should be applied after the first coat has dried. Pay particular attention to thoroughly soaking the end grain. Where possible, and for maximum protection, dip the end grains of the timber for a minimum of 3 minutes.

NOTE: product is milky out of the can but dries clear.

Documents