Product Data Sheet Show all documents

Sikalastic® Fleece-120

Polyester fleece reinforcement for Sikalastic® silane terminated polymers

Sikalastic® Fleece-120 is a polyester fleece used as reinforcement with Sikalastic® Silane Terminated Polymer systems.

  • Ensures the correct thickness of the base coat
  • Enhance the crack-bridging properties of the system
  • Enhance mechanical properties of the system
Product Data Sheet Show all documents

Usage

  • Reinforcement for Sikalastic® 650 Waterproofing System
  • For new construction and refurbishment projects
  • For roofs with many details and complex geometry even when accessibility is limited
 

Advantages

  • Ensures the correct thickness of the base coat
  • Enhance the crack-bridging properties of the system
  • Enhance mechanical properties of the system

Packaging

Rolls

Roll width

m per roll

30 cm

5 m
30 cm10 m
30 cm20 m

30 cm

50 m

70 cm50 m

100 cm

5 m
100 cm10 m
100 cm20 m
100 cm50 m

 

Colour

White

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

System component of following ETAG 005 approvals:

  • ETA -12/0308
Product Information

Chemical Base

100 % Polyester

Shelf Life

Product does not expire if correctly stored

Storage Conditions

The product must be stored properly in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +35 °C.

Mass per unit area

120 g/m2

 
System information

System Structure

For detailed information regarding system build-ups, please refer to the System or Product Data Sheet of the Liquid Applied Membrane.

Application

Application steps

SUBSTRATE QUALITY

The surface must be sound, of sufficient strength, clean, dry and free of dirt, oil, grease and other contamination.  Depending on the material the substrate must be primed or mechanically cleaned.  Grinding may be necessary to level the surface.  Suitable substrates are such as: concrete, bituminous felts and coatings, metal, brickwork, asbestos cement, ceramic tiles, wooden substrates.

For detailed information regarding substrate preparation and primer chart please refer to the project specific specification.

APPLICATION

Prior the application of the Sikalastic® 650, the priming coat, if used, must have cured tack-free.  For the waiting time/overcoating please refer to the PDS of the appropriate primer.  Damageable areas (handrails etc.) have to be protected with tape or plastic wrapping.

  

Sikalastic® Fleece-120 is applied in combination with Sikalastic® 650 waterproofing system.
1. Apply first coat of of Sikalastic® 650 with a consumption rate according to the PDS.  Work only so far in advance that the material stays liquid.
2. Roll in the Sikalastic® Fleece-120 and ensure that there are no bubbles or creases.  Overlapping of Sikalastic® Fleece-120 must be minimum 5cm and ensure overlaps are sufficiently wet to bond.
3. The roller may require only a little extra material to remain wet but no further significant material needs to be added at this stage.  It is important the fleece does not lift during installation – on some surfaces a spiked roller may assist installation.
4. After the coat is dry enough to walk on, seal the roof area with second coat of Sikalastic® 650 with a consumption rate according to the PDS.
Please note, always begin with details prior starting with waterproofing the horizontal surface.  For details follow step 1−3.

For detailed application information please refer to the project specific specification.

 

Documents