Product Data Sheet
Show all documents
EVERBUILD® FIX & FILL Expanding Foam

EVERBUILD® FIX & FILL Expanding Foam

One-part, quick-setting polyurethane foam

EVERBUILD® FIX & FILL is a quick-setting one-part polyurethane foam in aerosol form. FIX & FILL is supplied with attachable nozzles. The foam expands on application up to 150 % its original volume. Once cured the foam can be cut, sawn or plastered over after only one hour providing the working temperatures (can and surfaces) are between +5 °C to +30 °C, ideally +20 °C.

  • Quick setting - can be cut, sawn or plastered in 1 hour.
  • Economical in use - expands up to 55 times its original volume.
  • Fills irregular and broad gaps where most conventional fillers would fail.
  • Possesses insulating and sound deadening properties.
Expansion 45 litres (750 ml can) 30 litres  (500 ml can)   Cell Structure Medium fine Temp Res Of Cured Bead Long Term:  -40 to +80 °C Short Term: -40 to +100 °CBuilding Material ClassB3
Seek a Stockist Contact Us
Product Data Sheet
Show all documents

Usage

Filling
  • Gaps around pipe entries through walls.
  • Gaps around window frames, door frames.
  • Electrical wire chasing prior to plastering.
  • Deep joints prior to applying sealant or plaster.
  • Irregular gaps in stone, brick, concrete or plaster.
Fixing     
  • Door frames.
  • Timber structures.
  • Window sills and thresholds.
  • Window frames.
Insulating
  • Behind cladding to exterior walls.
  • Behind soffit and barge boards.
 

Advantages

  • Quick setting - can be cut, sawn or plastered in 1 hour.
  • Economical in use - expands up to 55 times its original volume.
  • Fills irregular and broad gaps where most conventional fillers would fail.
  • Possesses insulating and sound deadening properties.
Expansion 45 litres (750 ml can) 30 litres  (500 ml can)   Cell Structure Medium fine Temp Res Of Cured Bead Long Term:  -40 to +80 °C Short Term: -40 to +100 °CBuilding Material ClassB3

Packaging

500 ml and 750 ml aerosol

Product Details

Product Information

Shelf Life

15 months in original containers at stated storage temperatures.

Storage Conditions

Store upright between +5 °C and +25 °C. Pressurized container. Protect from sunlight and do not expose to temperatures above 50 °C. Do not pierce or burn the can even after use.  Store as flammable liquid.

Note: Elevated temperatures will reduce shelf life dramatically.
Technical Information

Compressive Strength

0.03 MPa (DIN 53427)

Tensile Strength

0.08 MPa (ISO 1926-79)

Reaction to Fire

B3 (DIN 4102-1)

Thermal Resistance

-40 °C to +80 °C

Resistance to Water Penetration

0 (ISO 2896-87)

Thermal Conductivity

0.036 W/m.k (DIN 52612)

Water Absorption

0.3 Vol % (DIN 53433)

Application

Application Information

Cutting Time

30-45 minutes (10 mm diameter)

Tack Free Time

~7 minutes (10 mm diameter)
Consumption

Yield

30-45 L (750 ml can) 20-30 L (500 ml can)
Application steps

SUBSTRATE PREPARATION

Ensure all surfaces are clean, sound and free from dust and loose particles. Moisten surfaces to be sealed with water. This assists the curing process.

Documents