Product Data Sheet Show all documents
EVERBUILD FILL & SKIM®

EVERBUILD FILL & SKIM®

A ready mixed lightweight plaster for patching

EVERBUILD FILL & SKIM® is a revolutionary new ready mixed plaster substitute, formulated using lightweight polymer spheres, to produce an easy to spread and smooth product which enables all tradesmen and DIY enthusiasts to produce a quality finish, normally only associated with a time served plasterer.  EVERBUILD FILL & SKIM® dries to a hard but flexible finish and is therefore suitable for wall or ceiling application and will fill holes down to 25mm in one application. Once, dry, EVERBUILD FILL & SKIM® will not shrink, sag or crack and is ready to paint or paper 24 hours after application. EVERBUILD FILL & SKIM® finishes smooth and requires little or no sanding.  

  • Easy to apply patching plaster
  • Simple to smooth over large areas
  • Ready mixed - re-sealable pack
  • Fill and finish in one go
  • Fills holes down to 25mm in one application
  • Will not shrink, sag or crack
Seek a Stockist Contact Us
Product Data Sheet Show all documents

Usage

  • For covering textured paint surfaces and for restoring old pitted/uneven plastered walls/ceilings in just one quick application.
  • For internal repairs over plaster, wood, brick, stone and rendering.
  • The ideal choice for electricians, plumbers, joiners and general builders as a one coat patching plaster for small repair jobs, e.g. over recessed cable trunking and around holes in walls where piping/sockets have been installed.  

Advantages

  • Easy to apply patching plaster
  • Simple to smooth over large areas
  • Ready mixed - re-sealable pack
  • Fill and finish in one go
  • Fills holes down to 25mm in one application
  • Will not shrink, sag or crack

Packaging

5ltr tub

Colour

White

Product Details

Product Information

Shelf Life

Use within 12 months.

Storage Conditions

Store in cool dry conditions between +5 and +25°C. Storage outside these parameters will dramatically reduce shelf life. Protect from frost.

Application

Application steps

APPLICATION

Stir EVERBUILD FILL & SKIM®  to a smooth paste. If product is too dry, add a few drops of water and re-stir. Load smoothing blade using a suitable spatula. Work over no greater than 0.5m² at a time towards centre of area to be coated. Apply in smooth curves ensuring even pressure and cover area. Work back with smoothing trowel over any ridges to smooth flat with rest of surface. Repeat over rest of area, covering 0.5m² at a time and “blending in” each area.

When filling a large surface area, it may not always be possible to achieve a completely level finish. However, EVERBUILD FILL & SKIM® is very easy to sand if necessary.

Deep holes up to 25mm can be filled in one application with no need to build up in several layers.

Coverage: Approx 0.75m²/litre at 6mm depth.

FINISHING: EVERBUILD FILL & SKIM® can be papered over, or painted with water or oil based paints as soon as the product is dry – approximately 24 hours – depending on depth and drying conditions. If priming is required, follow paint manufacturers instructions.

Documents