SikaGrout®-111 GP

Cement, selected fillers and aggregates, special additives

9 months

Store properly in dry conditions in undamaged and unopened original sealed packaging.

D_max: 1.0 mm

~2200 kg/m³ (wet density)

~0.07% (<1mm/M)

~0.55%

Water : mortar powder = 1 : 6.25 parts by weight. (4.0 – 4.5 litres of water per bag)

10mm minimum / 150mm maximum

+5°C minimum / +30°C maximum

+5°C minimum / +30°C maximum

Depends on the substrate roughness and thickness of layer applied. As a guide, 1 bag yields approximately 13.0 litres of mortar

As a guide 1 bag yields approximately 13 litres of mortar

Place the correct amount of water into a forced action grout mixer or in a clean, suitable mixing vessel. Slowly add complete bag(s) of SikaGrout® 111 GP into the water and continuously mix for 3 minutes with the mixer to achieve a uniform and lump-free consistency. Alternatively, use a slow speed drill (200-500 rpm) and spiral paddle mixer.

Pour the mixed grout into the header box/hopper ensuring continuous grout flow during the complete grouting operation to avoid trapping air. Use steel banding or chains to assist flow where necessary. For large volume placement, grout pumps are recommended.
For cold weather working, consider using warm water to assist with achieving strength gain and other physical properties.

After the grout has initially hardened, remove formwork and trim edges while concrete is ‘green’. Protect the fresh material from premature drying using appropriate curing method e.g. curing compound such as Sikafloor® ProSeal, moist geotextile membrane, hessian, polythene sheet, etc. In cold weather, apply heat blankets to maintain a constant temperature.

Clean all tools and application equipment with water immediately after use. Hardened/cured material can only be mechanically removed.