Product Data Sheet Safety Data Sheet Show all documents
Sika® Water Seal

Sika® Water Seal

Solvent based waterproofer and protector for brick, concrete and stone

Sika® Water Seal is a waterproofing solvent based water seal for masonry, to protect structures against rain, damp and frost. Upon application Sika® Water Seal penetrates to a depth of 5mm, lining the pores with a water repellent coating without significantly changing the appearance or affecting the breathing property of the wall. Prevention of rain and damp penetration with Sika® Water Seal also aids in preserving the heat insulating properties of the wall. This treatment is known to be effective up to 10 years, depending upon substrate, absorbency, application rate and position.

  • Deeply penetrating, water repellent.
  • Colourless, long lasting.
  • Allows treated surfaces to breathe.
  • Protects surface from discolouration due to pollution.
  • Helps to reduce efflorescence.
  • Economical and easy to use.
  • Brush or spray applied.
Seek a Stockist Contact Us
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • Substantially reduces rain and damp penetration, protects the surface from discolouration and weathering and aids in preventing efflorescence and spalling of the surface from frost attack.
  • Suitable for application to vertical surfaces only.
  • In industrial areas, the sealing of masonry with Sika® Water Seal protects the surface from attack by the acidified atmosphere and aids in preventing discolouration by smoke.
 

Advantages

  • Deeply penetrating, water repellent.
  • Colourless, long lasting.
  • Allows treated surfaces to breathe.
  • Protects surface from discolouration due to pollution.
  • Helps to reduce efflorescence.
  • Economical and easy to use.
  • Brush or spray applied.

Packaging

5L tin

Colour

Colourless liquid

Product Details

Product Information

Chemical Base

Silicones in hydrocarbon solvent

Shelf Life

Up to two years when stored as recommended.

Storage Conditions

Keep away from food. Store in unopened containers in cool (5 to 25°C), dry conditions away from sources of ignition and heat.

Density

0.79 g/cm3 at 20°C

Flash Point

38°C

Application

Consumption

Consumption

Coverage will vary according to the porosity of the surface treated and will be from 8m² per litre on hard brickwork to 3m²/ltr on highly porous surfaces (the latter may require two coats).
Application steps

APPLICATION INSTRUCTIONS

APPLICATION

Stir before use. Apply by brush or low pressure spray in one coat, in conditions of adequate ventilation. The Sika® Water Seal is flooded on to the surface so that a run down of approximately 300mm is obtained.

CLEANING OF TOOLS

Clean all equipment and brushes immediately after use with white spirit.

Documents