Product Data Sheet Show all documents
EVERBUILD® JETCEM® PLASTER

EVERBUILD® JETCEM® PLASTER

A high strength patching plaster

EVERBUILD® JETCEM® PLASTER is a high strength plaster in powder form which mixes easily with water to form a creamy lump free paste that is the ideal choice for most patching repairs. The product dries hard in 1 hour to a smooth finish which can be further sanded if desired. With added PVA powder, this product will not shrink or crack and is strong enough to accept nails or screws.  

  • Easy mixing, just add water.
  • Adheres to most common building surfaces.
  • Overpaintable.
  • Doesn't shrink or crack.
Product Data Sheet Show all documents

Usage

  • Plaster
  • Plasterboard
  • Brick
  • Wood
  • Stone
  • Most other building materials

Advantages

  • Easy mixing, just add water.
  • Adheres to most common building surfaces.
  • Overpaintable.
  • Doesn't shrink or crack.

Packaging

6 kg Bag

Colour

Off White

Product Details

Product Information

Chemical Base

Plaster of Paris

Shelf Life

24 months in original unopened bag. This will reduce significantly once opened.

Storage Conditions

Store in cool dry conditions between +5 °C and +25 °C.  Storage outside these parameters will significantly reduce shelf life.

Density

ca. 1.2 g/cm³

Application

Application Information

Mixing Ratio

1 part water to 2.5 parts powder by volume (1 L water to 3 kg powder)

Layer Thickness

Maximum 38 mm (1.5 inch) in one layer

Ambient Air Temperature

>10 ºC

Pot Life

20 to 30 minutes
Application steps

APPLICATION

  • Always use a clean mixing vessel and add approx. 2 ½ parts powder to one part by volume clean cold water and mix immediately to a smooth paste. The mixed plaster will remain workable for 20-30 minutes.
  • Smooth the EVERBUILD® JETCEM® PLASTER over the repair with a trowel.
  • Finish with a wet knife, if sanding is desired fill the hole slightly proud to allow for sanding down.
 

FINISHING

  • EVERBUILD® JETCEM® PLASTER is normally sandable and overpaintable after approximately one hour.
  • Once dry, sand to a smooth finish.
  • EVERBUILD® JETCEM® PLASTER may be painted or papered when dry.

Documents