Product Data Sheet Safety Data Sheet Show all documents
EVERBUILD TECNIC® HM SILICONE

EVERBUILD TECNIC® HM SILICONE

Sanitary Grade Silicone

EVERBUILD TECNIC® HM SILICONE is a premium, acetoxy curing silicone sealant engineered to provide enhanced body and superior toolability in sanitary applications. It contains powerful anti-fungal compound to prevent mould and fungal growth to the sealant in areas of high humidity.

  • Protection against mould, fungal and bacterial growth based on 10 years accelerated ageing under ISO22196 and AATCC 30 part 3.
  • Waterproof seal.
  • Flexible - Movement accomodation of +/- 20%.
  • High viscosity formula for quick easy tooling.
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • Sealing around all kitchen and bathroom sanitary areas.
  • Expansion joint and corner joint sealing of ceramic tiles.
  • Sealing around sanitary fittings in domestic and municipal applications.
  • General sealing in areas subject to high humidity levels.
 

Advantages

  • Protection against mould, fungal and bacterial growth based on 10 years accelerated ageing under ISO22196 and AATCC 30 part 3.
  • Waterproof seal.
  • Flexible - Movement accomodation of +/- 20%.
  • High viscosity formula for quick easy tooling.

Packaging

310 ml Cartridge

Colour

White, Limestone white, Translucent, Manhattan Grey, Anthracite, Jasmine

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

  • Tested to ISO11600 F/G20LM and BS EN15651.
Product Information

Shelf Life

24 months from date of manufacture.

Storage Conditions

Store between 5 ˚C and 25 ˚C in dry conditions.
Technical Information

Shore A Hardness

23

Modulus of Elasticity in Compression

0.28 N/mm2 (ISO 11432)

Elongation at break

>350 %  (ISO 8339)

Movement Capability

+/-20 % (ISO 9047)

Elastic Recovery

>95 % (ISO 7390)

Shrinkage

~ 5 % (ISO 10563)

Service Temperature

-40 °C to +150 °C

Application

Application Information

Curing Time

2-4 mm/24 hours (23 °C and 50 % RH)

Skin Time

20 min at 20 °C (dependent on temperature and humidity)
Application steps

APPLICATION INSTRUCTIONS

  • All surfaces to be sealed must be clean and dry and free from friable material.
  • Fill deep gaps and voids with Everbuild® Expanding Foam, then trim back level with bath/shower tray before applying Sealant.
  • When applying to plastic & acrylic baths, fill bath half full with water whilst sealing and during cure. This provides the mid point of any movement that will be encountered.
  • Always tool sealant down to ensure a proper bond is achieved.
  • Tool within 15 minutes of applying.
 

Documents