Sarnacol®-2116

Water based synthetic resin

18 months from date of production

The product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +30 °C. Always refer to packaging.

~1,00 kg/l (+20 °C)

Liquid

+5 °C min

+5 °C min

The strength required for the intended use is achieved after approximately 24 hours, depending on the weather conditions.
Final strength is achieved after approximately 1 to 4 weeks and depends on temperature and humidity.

~500–800 g/m² for a gravel layer of 50–60 mm. Each additional gravel layer of 10 mm requires ~100 g/m².

These figures are theoretical and do not allow for any additional material due to surface profile, variations in level or wastage etc.

Membrane surface must be clean, dry, free of cleaning agents, oil and grease.

Gravel must be dry or only slightly moist.

Reference must be made to further documentation where applicable, such as relevant method statement, application manual and installation or working instructions.

General Information
Sarnacol®-2116 must be stirred before use.
Dilute with water in a ratio of 1 part water to 10 parts adhesive to adjust fluidity.
Keep adhesive container closed whenever adhesive is not being used to prevent surface skinning.

Bonding and binding

Application must only to be carried out in dry weather conditions.
The adhesive is evenly sprayed or poured out of a watering can onto the gravel. Sarnacol®-2116 dries to a transparent and slightly elastic film.

Cleaning

Use water or Sarna Cleaner to remove adhesive residue from the roof membrane.

Clean all tools and application equipment with water immediately after use. Hardened material can be removed by Sika® Sarna Cleaner