Sika® Pile Pak

Conforms to the requirements of BS EN 934-2 Table 2

DoP 63924114, certified by Factory Production Control Body 1029 and provided with the CE mark
DoP 55377145, certified by Factory Production Control Body 0120 and provided with the UKCA mark

Modified Polycarboxylate / Thixotrope

12 months from date of production if stored properly in undamaged containers

Store in dry conditions at temperatures between +5°C and +25°C. Protect from direct sunlight and frost.

0.65 kg/l (at +20°C) (loose)

< 0.10% w/w (chloride free)

< 0.60% w/w (alkali content)

Air Entrainment - Normally a minimal increase
Effect of Overdosing - Increased workability and segregation
Sulphate Content - 0.12% max

Sika® Admixtures: - All Sika admixtures can be considered
Other product compatibility information available on request
Cements: all cements combinations may be considered

• Sika® Pile Pak should be added to the mixer at the recommended dose subsequent to the batching of concrete.
• Concrete should be remixed at full RPM after addition for at least 1 minute per cubic metre

• The standard rules of good concreting practice, concerning production as well as placing, are to be followed. Refer to relevant standards. Fresh concrete must be cured properly.
• Sika® Pile Pak should not be added to dry cement.
• Sika® Pile Pak should be added to mixed concrete.
• When using Sika® Pile Pak a suitable mix design is required and local material sources should be evaluated.
• Support from our Technical Department is recommended.

1 – 2 bags per m³