Product Data Sheet Show all documents
Parex® Render Bead Adhesive

Parex® Render Bead Adhesive

Render Bead Adhesive

Parex Render Bead Adhesive is based on new technology making it the first hybrid polymer grab adhesive especially created for render beads. This superior adhesive has the ability to bond virtually anything to everything in both wet and dry conditions. With incredible initial grab, high bonding strength, Parex Render Bead Adhesive is the number one choice for render bead application.  

  • High initial Grab
  • Excellent Bond Strength
  • Can be applied to wet surfaces
  • Designed for use with Parex Mineral Renders
Contact Us
Product Data Sheet Show all documents

Usage

Parex Render Bead Adhesive is capable of bonding of almost all materials, porous and non-porous, such as, bricks, blockwork, stone, render boards, plasterboard, concrete, stainless/aluminium beads, stonewool, EPS insulation.

Advantages

  • High initial Grab
  • Excellent Bond Strength
  • Can be applied to wet surfaces
  • Designed for use with Parex Mineral Renders

Packaging

350 ml cartridge

Colour

White thick paste

Product Details

Product Information

Shelf life

Use within 12 months.

Storage conditions

Store in cool, dry conditions between +5 and +25 °C. Storage outside these parameters will dramatically reduce shelf life.

Application

Consumption

Consumption

Approx. 12 linear meters for a 6 mm diameter bead.
Application steps

APPLICATION INSTRUCTIONS

All surfaces to be bonded must be sound and clean. For a temporary fix prior to render application follow the procedure below.

Cut the tip of the cartridge, taking care not to damage the thread. Apply nozzle and cut cleanly at a 45 degrees angle with an opening of approximately 6–10 mm diameter. Apply using a standard sealant gun directly to back of one surface only. Immediately place the bead into position and secure with good, even pressure. Fix at maximum 300 mm centres. Where blockwork alignment doesn't allow the use of Parex render bead adhesive the traditional method of fixing the bead with the render to be used should be followed in those areas.

NOTE: Parex Render Bead Adhesive will skin over within approximately 30 minutes. Through cure will be approximately 1.5 mm in depth per 24 hours. his may be slower on non-porous surfaces.

Documents