Parex Eproseal

A blend of Portland cements, quality graded aggregates and chemical modifiers

6 Months

Store properly in dry conditions in undamaged and unopened original sealed packaging

7.5 to 8.5 litres per 25kg bag.

+5°C min / +35°C max

+5°C min / +35°C max

~330 mins @ 20ºC

The coverage obtained will depend on the substrate surface.
Coarse surface
2.5 - 3kg/m2/coat
8.3 - 10.0m2 per 25 kg unit
Smooth surface
2 - 2.5kg/m2/coat
10.0 - 12.5m2 per 25 kg unit

~2kg to 3kg/m2/coat depending on substrate.

Parex Eproseal is supplied in 25kg bags. The water requirement to produce the coating is 7.5 to 8.5 litres per 25 kg of dry material. Pour the required quantity of water into a suitable mixing vessel. Slowly add the powder to the water whilst continuously mixing. Mechanical mixing is recommended using a slow speed high torque drill with a Mortar Stirrer. Mixing should be continued for three minutes after all the powder has been added to the mixing water to obtain a “creamy” consistency.

Parex Eproseal is applied in two coats. Brush or spray apply the first coat in a horizontal direction down to the fillet level. After 24 hours seal fillet with a suitable plugging mortar, leaving weep holes free. Apply a second coat of Eproseal in a vertical direction covering the fillet with the coating. Remove weep hole taps and seal with a suitable plugging mortar.

In warm or windy conditions, mist spraying may be used to compensate for moisture loss. In tanking applications a through flow of air is required to prevent condensation.

Clean all tools and application equipment with water immediately after use. Hardened/cured material can only be mechanically removed.