Product Data Sheet Show all documents
Parex Dry Pack C

Parex Dry Pack C

Dry packing mortar

Parex Dry Pack C is a one component, cementitious mortar containing special shrinkage compensating components.

  • Pre-bagged for quality and consistency.
  • Easy to mix and apply.
  • Shrinkage compensated.
  • Vertical and horizontal application.
  • Chloride free.
  • Suitable for voids up to 100mm. 
  • Negates the need for shuttering, saving time and cost. 
Product Data Sheet Show all documents

Usage

  • All dry packing applications.
  • Support of precast concrete units.
  • Placement in gaps to form a fill without the use of shuttering.
  • Horizontal and vertical gaps.
  • For external and interior use.
 

Advantages

  • Pre-bagged for quality and consistency.
  • Easy to mix and apply.
  • Shrinkage compensated.
  • Vertical and horizontal application.
  • Chloride free.
  • Suitable for voids up to 100mm. 
  • Negates the need for shuttering, saving time and cost. 

Packaging

25kg bag

Colour

Grey powder

Product Details

Product Information

Composition

Portland cement and special shrinkage compensators

Shelf life

9 months

Storage conditions

Store in original unopened, sealed and undamaged packaging in dry and cool conditions.

Density

~2150 kg/m3
Technical Information

Compressive strength

1 day

~20 N/mm2

7 day

~40 N/mm2

28 day

~50 N/mm2

Typical properties @ 20ºC

Reaction to fire

Euroclass A1

 

Application

Application Information

Mixing ratio

2.0 to 2.5 L of water for 25kg powder

Layer thickness

5.0 mm min. / 100 mm max.

Ambient air temperature

+5°C min. / +30°C max.

Substrate temperature

+5°C min. / +30°C max.

Setting time

Initial set: ~210 mins @ 20ºC

Final set: ~240 mins @ 20ºC
Consumption

Yield

Each 25kg bag of Parex Dry Pack C will yield approximately 12 litres of mixed material.
Application steps

MIXING

Parex Dry Pack C can be mixed with a low speed (<500 rpm) hand drill mixer. For larger volumes (i.e. 2 to 3 bags, or more) mixed at once, a forced action mixer shall be used. The amount that can be satisfactorily mixed at a time will depend on the type and size of mixer used. 
Pour the recommended amount of water into a suitable mixing container. Whilst stirring slowly, gradually add the powder to the water and mix thoroughly until homogeneous and the mortar has formed a consistency suitable for ramming into place.

APPLICATION

Place the Parex Dry Pack C mortar firmly into the prepared gap in layers. Use a suitable ramming tool to ensure complete filling of the gap and compaction of the mortar. Repeat this operation until the void is completely filled and compacted. Allow the mortar to stiffen then finish the exposed surface with a dampened steel trowel.

CURING TREATMENT

Protect the fresh mortar immediately from premature drying for a minimum of 3 days using an appropriate curing method (e.g. curing compound, moist geotextile membrane, polythene sheet, etc.). 
Curing compounds shall not be used when they adversely affect subsequently applied products and systems.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with water immediately after use.
Hardened/cured material can only be mechanically removed.

Documents