2016
Hull, United Kingdom

Sika supplied the concrete repair and total corrosion management system to extend the lifespan of a city centre flyover, with the products’ effective and easy-use enabling the vital refurbishment to be carried out with minimal disruption to the thousands of commuters who use the route daily.

Anlaby Road flyover is a four-lane carriageway road bridge on one of the main commuter routes to Hull central, spanning the main network rail route into the city centre.

Bridge Repair Project Requirements

The concrete bridge, built in 1964, displayed major signs of carbonation induced spalling to columns and deck soffits above the rail lines. Contractors, BOSA Contracts, on behalf of Hull City Council, required a practical repair solution which extended the lifespan of one of the city’s arterial routes without impacting on daily road and rail commuter journeys or impeding pedestrians.

Anlaby road rail bridge
Anlaby road rail bridge

Sika Concrete Repair Solutions

Work on the bridge’s repair began in March 2016. The full refurbishment involved structural concrete repairs, corrosion inhibitors, anticarbonation coatings and safety fencing. Global product manufacturer, Sika, supplied the project’s concrete repair and total corrosion management system.

"Sika products were specified due to their excellent historical performance, giving all those involved in the flyover’s refurbishment peace of mind. As a manufacturer, Sika was able to supply a full range of materials to solve the whole range of repair issues. The Sika® MonoTop® range is a particularly good performer when applied to soffits, especially where limited time is a factor. This not only helped coordinate a smooth-running works programme that enabled repairs to be completed to the highest quality and without disruption to vital road and rail routes, it assisted with administrative issues such as Quality Assurance paperwork" Richard Snow, Director at BOSA Contracts

After the repairs had been carried out, Sika® FerroGard®-903+ corrosion inhibitor was applied to the areas outside of the repair areas. The corrosion inhibitor extends the service life of any reinforced concrete structure without the need for actual concrete removal. Once applied, it penetrates the surface and diffuses in vapour or liquid form to the concrete’s embedded reinforcing bars, forming a protective layer on the steel surface to control corrosion caused by the presence of chlorides as well as by carbonation.

Sika® Armorcrete®, a one-part, flowable, cementitious, micro-concrete was then used for shutter and pour repairs to large sections of the supporting columns and piers. For smaller, hand-placed repairs, the majority of which were carried out to deck soffits and abutments, Sika® MonoTop®-610, a high-performance, cementitious steel reinforcement protective coating and bonding primer was applied in preparation for concrete repair mortar, Sika® MonoTop®-615.

To all sections of the structure, except the lower supporting column sections, Sikagard®-552W, a one component, water-dispersed, adhesion-promoting primer and Sikagard®-550 W Elastic, a solventfree, crack-bridging, plasto-elastic anti-carbonation coating, were applied. The lower column sections were coated with Sika® Poxitar®, an epoxy-anthracene oil-combination coating with mineral fillers to form tough, splash protection against passing traffic.

The flyover repairs, along with the corrosion management system, were completed in October 2016. These were finalised to the client’s strict deadline and full satisfaction. The superb works programme drawn-up by BOSA, which included staggered shift patterns and out-of-hours working, ensured travel disruption was minimalised for road and rail commuters.

Thanks to the superb experience and diligence of BOSA’s on-site teams and the proven quality of Sika’s concrete repair and total corrosion management system, Anlaby Road flyover has been given a new lease of life, allowing it to remain a landmark part of Hull city centre’s travel network for many years to come.

Products Used

Sika® Monotop®-610

Sika® Monotop®-615

Sikagard®-550 W Elastic

Sika® FerroGard®-903+