Product Data Sheet Show all documents
Parex Tecgrip V

Parex Tecgrip V

2-COMPONENT POLYESTER RESIN ANCHOR GROUT

Parex Tecgrip V is a two-component, polyester resin based, anchoring grout. It consists of a low viscosity polyester resin plus a catalysed filler. The two components are mixed to produce a filled resin grout, which may be poured or pumped into suitably prepared anchor holes. The mixed grout is coloured dark grey and is used for downward facing holes where the hole diameter is up to 25mm greater than the bolt or bar diameter. The Product is used for the fixing of steel bolts into pre-drilled holes within concrete, rock, brickwork, stonework, masonry and other substrates capable of supporting the required load. Available in both winter and summer formulations, giving a wide range of application temperatures.  

  • Rapid setting.
  • High early strength gain.
  • Pre-batched for ease of mixing.
  • Contractor friendly packaging size.
  • Corrosion resistant.
  • Non-shrink.
  • Tested in accordance with the relevant parts of BS 6319 and BS 5080.
  • Winter and summer grades available.
Product Data Sheet Show all documents

Usage

The Product can be used with the following:        
  • Base plates.
  • Rail tracks.
  • Starter bars and dowels.
  • Safety fences and balustrades.
  • Reciprocating machinery.
  • High impact loads.

Advantages

  • Rapid setting.
  • High early strength gain.
  • Pre-batched for ease of mixing.
  • Contractor friendly packaging size.
  • Corrosion resistant.
  • Non-shrink.
  • Tested in accordance with the relevant parts of BS 6319 and BS 5080.
  • Winter and summer grades available.

Packaging

4.415 kg pail (A+B)

Colour

Dark grey when mixed

Product Details

Product Information

Shelf life

18 months from date of manufacture

Storage conditions

Store properly in dry conditions in undamaged and unopened original sealed packaging. Storage at high temperatures or high humidity may reduce the shelf life.

Density

~1800 kg/m³

 
Technical Information

Compressive strength

2 hours

~40 N/mm²

1 days

~80 N/mm²

7 days

~95 N/mm²

Modulus of elasticity in compression

~16 kN/mm² at 7 days

Tensile strength

~17 N/mm² at 7 days

Application

Application Information

Ambient air temperature

Winter

Minimum 5°C

Maximum 20°C

Summer

Minimum 15°C

Maximum 35°C

Substrate temperature

Winter

Minimum 5°C

Maximum 20°C

Summer

Minimum 15°C

Maximum 35°C

Setting time

Winter grade

Summer Grade

~8-12 minutes

~18 - 22 minutes

(above 20°C setting will be rapid)(below 10°C setting will be extended)
Application steps

MIXING

Place contents of resin can into a plastic container or pail. Slowly add catalysed filler whilst mixing. Continue mixing until a uniform colour is achieved (approximately 2 minutes). Correct mix proportioning must be used to achieve the designed anchor strength.

APPLICATION

Pour mixed grout into prepared holes, rodding if necessary to ensure grout flows to the bottom of the hole. Once grout has been placed insert bar into hole and gently twist and press home to the required depth. The bar should be left undisturbed until the grout has hardened.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with Sika® Thinner C Cleaner immediately after use. Hardened / cured material can only be removed mechanically.

 

Documents