UsageS-Felt T-300 is used as a separation and levelling layer between Sika Liquid Plastics liquid applied membrane and incompatible substrates. S-Felt T-300 can also be used as a protection layer between Sika Liquid Plastics liquid applied membranes and any protective topping or pavement.
- Bitumen resistant
- Non decaying
- Suitable for mechanical fastening (drill proved)
S-Felt T-300 rolls are wrapped individually in transparant PE-foil.
|Packing unit||see price list|
|Roll length||50 metres|
|Roll width||2 metres|
APPROVALS / STANDARDS
- Reaction to fire according to EN 13501-1
- Quality management system EN ISO 9001/14001
100% PES fibres
5 years from date of production and according to defined storage conditions in unopened, undamaged, original packaging.
Rolls must be stored between +5 °C and +30 °C, protected from direct sunlight, rain and snow. Do not stack pallets of rolls or any other material during transport or storage.
2 metres (+/- 10%)
|2.50mm (+/- 10 %)|| |
Mass per unit area
|300g/m2 (+/- 10 %)|| |
All types of Sika Liquid Plastics liquid applied membranes
≥ 300 N/50mm
≥ 350 N/50mm
Reaction to Fire
On polystyrene board
Ambient Air Temperature
-20 °C min. / +60 °C max.
-30 °C min. / +60 °C max.
Installation works must be carried out only by Sika Liquid Plastics instructed contractors for liquid applied membranes.
Installation of some ancillary products, e.g. contact adhesives/cleaners is limited to temperatures above +5 °C. Please observe information given by Product Data Sheets.
Special measures may be compulsory for installation below +5 °C ambient temperature due to safety requirements in accordance with national regulations.